Non Destructive Testing

The new OmniScan™ X3 64 flaw detector delivers improved power and performance to Olympus’ field-proven phased array ultrasonic testing (PAUT) product line. This 64-channel instrument has the pulser capacity to drive phased array (PA) probes with a larger number of elements, increasing the data acquisition speed for total focusing method (TFM) imaging. Users can exploit its [...]

Aboveground storage tanks are subject to regular inspections prescribed by the applicable codes such as API 653 and EMUUA 159. It is well known that the tank bottoms are typically inspected using Magnetic Flux Leakage (MFL) floor scanners such as the Floormap®X. These sensitive tools enable the detection of the smallest pits and flaws. When it [...]

The F-35 Lightning II is an all-weather stealth combat aircraft that is intended to perform warfare strike missions and electronic surveillance capabilities at speeds up to 1.6 Mach. Composites comprise 35% of the airframe weight, with the majority being bismaleimide, as well as some carbon nanotube-reinforced epoxy, which has a tensile strength of approximately 100 times [...]

The increased use of optical fiber has seen a greater focus on the precise control and measurement of its diameter. That is due to the diameter being vital for a wide range of fields, from high-speed optical communication to ultra-high sensitivity sensing. Handling optical fiber before measurement can damage the fiber permanently, particularly when multiple-point measurements [...]

Carestream’s Non-Destructive Testing (NDT) group has released the HPX-DR 2530 PC, a non-glass detector that enables faster throughput for imaging, as well as rapid analysis and reporting. The durable non-glass design is built for the tough conditions of NDT work, especially portable radiography. With a 145 μm resolution, the HPX-DR 2530 PC provides highly detailed imaging [...]

We are proud to announce that the Novosound Belenus-X corrosion monitoring sensor is certified for operation in ATEX, IECEx and UKEX Zone 0 locations. Designed and manufactured in line with international intrinsically safe standards, this latest certification extends the potential application of the Novosound Belenus-X to operate in areas where explosive gas atmosphere is present continuously [...]

The new DRC 3643 NDT rounds off DÜRR NDT’s DRC product range of robust flat panel detectors for industrial digital radiography. Thanks to its portability and large active area of 36 x 43 cm, the new detector is particularly well suited for corrosion and erosion inspections on pipes in compliance with DIN EN ISO 20769. With [...]

Avonix Imaging is excited to announce they will be hosting A-TEC 2022 on September 20 and 21, at the Minneapolis Marriott Northwest Elm Creek Amphitheater in Minnesota. The A-TEC Conference is a bi-annual Educational and Networking event for professionals involved in Radiographic Nondestructive Testing, specifically 2D Digital X-ray and 3D Computed Tomography. The content and experiences [...]

Not everybody fully understands robots, even those that intend to use them. But they do understand NDT. Eddyfi Technologies doesn't consider replacing humans and inspectors with robots, but giving humans the ability to further extend the reach of inspection to areas otherwise inaccessible, dangerous, or expensive to reach. Removing the human from the risk zone, but [...]

Use of adhesive bonding to assemble composite structures is not new. It’s been widely used in every major end market the composites industry serves, ranging from automotive and marine to wind and defense. In high-performance applications like aerostructures, however, use of unitized, integrated structures has been limited by lack of confidence in the quality of adhesively [...]